I hope this helps please post a comment to let me know if it does. (Where xxx in the above represents the number of pixels wide and the number of pixels tall the session should be. ![]() The target of such a shortcut should read: The RDP file may look like this: screen mode id:i:2 span monitors:i:1 use multimon:i:1 First, list the monitors connected to the local computer. f uses up both screens -g 90 produces a massively wide window. What is cause, and how can I resolve the issue. exe /multimon /span fill in the RDP connection info and connect. You can either use the switch on-demand by entering mstsc /w:xxx /h:xxx at a command prompt (where xxx represents the number of pixels) and then connect as usual, or you can make use of the switches in a shortcut. Save the RDP file, and open it in a text editor like Notepad. 2 Answers 2 I have multimonitor and neither of those options work. 8 (585) TT11 Mens Zone Performance T-Shirt. The /w and /h switches allow you to set a precise number of pixels which the session should be in width and in height. A Custom Resolution If the /span switch just doesn't cut it for you, and for some reason (perhaps you have a large monitor) you want a window to open at a non-standard screen resolution, then there are commands which can help you, too. Select all Open in new window However, I can confirm that my 3 monitors are not the same height, and the switch still works perfectly fine for me.Ģ. The monitors must all have the same height and be aligned vertically If you want to use the switch in a shortcut, I suggest you implement it as follows:įor the /span switch to work, the MSTsc.exe help guide states that: When you press OK, you will be presented with the typical connection dialog, where you connect as normal. To get going, all you need to do is go to Start, Run and enter mstsc /span. open a new session to a remote Terminal Server or computer with RDP enabled, and cause the new session to fill all the monitor space on your desktop. The power of /span The truth is, there is a /span switch which can do exactly that. ![]() may be the enterprise version of windows 8 support it. ![]() It doesn't seem possible to open a session which spans across all your monitors.ġ. To span across monitors, the monitors must use the same resolution and must be aligned horizontally (that is, side-by-side). /span and /multimon parameter are ignored so are the proper lines in the rdp file edting the rdp session options does not help either. Having a dual- or triple-monitor configuration does a lot to boost your productivity, but what about when you want to connect to a Terminal Services session? By default, a Terminal Services screen can either be configured to fill your screen, or to a number of pre-defined screen resolutions.
0 Comments
Leave a Reply. |